Fiat Panda - left or right low beam not functioning
| Data sheet | |
|---|---|
| Manufacturer | Fiat |
| Vehicle model | Panda 169 |
| Engine | All models |
| Year of manufacture | From 2004 |
| Symptoms | Left or right low beam not functioning |
Important safety note
Left or right low beam defective without error entries in the control unit
If this defect is detected in the vehicle model mentioned above, a possible cause could be a defective connector on the body computer in the front left footwell.
If the low beam is permanently switched on, the contacts in the connector housing may burn.
If all other causes, such as bulbs, cable connections or fuses, have been ruled out as part of the fault diagnostics, disconnect the grey connector on the body computer and check PIN 7 (grey black cable) and PIN 8 (grey cable) for any damage.
If a repair is required, all damaged parts must be replaced with new ones.
The vehicle manufacturer offers a repair kit as a spare part. (part number 71745167)
Plug connection on the body computer (A20).
Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval; indication of the document source is also required. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.
Not helpful at all
Very helpful