Renault Megane IV - Vibrations and noises while car is being driven

Data sheet
ManufacturerRenault
Vehicle modelMegane IV
Year of construction2018
SymptomsVibrations and noises while car is being driven
Other vehicles affectedAlso applies to the following models with automatic transmission (transmission code DW5): ESPACE V (RFC), KADJAR (HA,HL), MEGANE IV (B9A/M/N_), MEGANE IV Grandtour (K9A/M/N_) and TALISMAN.

Important safety note Technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their day-to-day work. The information provided on this website is intended for use by suitably qualified personnel only.

Vibrations and noises occur during the driving of a Renault Megane IV

With such a repair job, the customer complains that vibrations and noises, starting at the front axle, can be heard during driving of the vehicle. On a test drive it was discovered that vibrations, together with a rattling noise, were present during power transmission to the drive axle. The cause of the above-mentioned problem is a too low / an insufficient oil level for the automatic mode.

 

Remedy: Replenish the automatic transmission oil.

 

So as to avoid contamination of the fresh oil with residues of the used oil remaining in the system, it is imperative to flush out the gearbox with a suitable servicing and cleaning machine. An update of the transmission software is also to be carried out as part of this procedure. Finally a test drive should be performed in order to run checks on the repair work.

 

Spare partsOE part number
Oil(FFL-7)77 11 782 057
Oil filler cap seal82 00 201 381
IMPORTANT

Please note that such work should only be carried out by an authorised specialist workshop and that the vehicle manufacturer's repair and maintenance instructions must be observed!


THIS MAY ALSO BE OF INTEREST TO YOU

Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval; indication of the document source is also required. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.