Citroen Berlingo - Failure of the low beam | HELLA



Model years 2002-2008

Failure of the low beam

If a customer complains about the above problem, this could be caused by a frayed cable harness. Additionally there may be electrical failures/malfunctions. The cable harness runs from the fuse box in the engine compartment (front left) through a passage opening in the wheel arch to the headlamps. Since the cable is not protected at this opening, it may become frayed here due to vibration. This then leads to the above-mentioned problems. In this case, the damaged areas on the cable must be repaired. Then protect the cable harness in the area of the passage hole with a corrugated pipe in order to avoid repeated chafing. Below is a summary of corrugated pipes. For details on installation material, refer to Hella Bulletin with order 9Z2 999 029-115.

Important safety note Technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their day-to-day work. The information provided on this website is intended for use by suitably qualified personnel only. Reprinting, distribution, reproduction, exploitation in any form or disclosure of the contents of this document, even in part, is prohibited without our express, written approval and indication of the source. The schematic illustrations, pictures and descriptions serve only for the purposes of explanation and representation of the instructions and cannot be used as a basis for installation or assembly work. All rights reserved.