Idle speed controller function
Here you will find useful basic information and important tips relating to idle speed controllers and idle speed actuators in vehicles.
Important safety note
The idle speed actuator is a bypass air valve. The idle speed actuator shown as an example consists of a closed cast housing with flange-mounted solenoid valve servo unit. Attached to this is a nozzle holder, which releases different air cross sections by moving the servo unit, and can therefore control the air mass flow when the throttle valve is closed.
The idle speed actuator is responsible for regulating the engine speed as part of the overall idle-speed control of the engine management system. If there is a sudden change to the engine load condition when in idle mode (e.g. air-conditioning system being switched on, creep speed in 1st gear, or activation of another electrical consumer), air and fuel are also required in order to prevent the engine from stopping. If the engine speed falls below a certain critical value, which is stored as a constant in the control unit memory, the solenoid valve is activated and an increased air flow rate is achieved. The opening time of the injection valves is simultaneously extended and adapted to the engine's requirements.
A faulty idle speed actuator can manifest itself as follows:
Causes for failure of the idle speed actuator can be:
The following test steps should be considered during troubleshooting:
Check the voltage supply with the ignition switched on.
An Ohm measurement must only be carried out in a de-energized state (plug connection removed).
Use the multimeter to measure the coil resistance between the two connection pins of the idle speed actuator.
Check the coil for a winding short circuit between the two connection pins.
Check the coil for a winding interruption between the two connection pins.
Check the coil for short circuit to frame – between pin 1 and component housing, and between pin 2 and component housing.
Unscrew the servo unit from the housing. Visual check to determine whether the bypass opens and closes when the valve rod is actuated.
Read out fault code.
Before mounting the idle speed actuator, the supporting surface must be cleaned and, if necessary, the flange seal must be replaced.
Observe the tightening torque!
Please observe the specifications provided by the respective vehicle manufacturer.
Not helpful at all