Honda S2000 - Delayed acceleration | HELLA

Honda

S2000

All models from VIN-JHMAP1-5S200063

Delayed acceleration

If on these vehicles there are complaints that the engine runs poorly at idle, or only responds with a delay on acceleration, the problem may be caused by a faulty intake pipe pressure sensor. During faultfinding it should also be checked whether a poor contact in the multiway connector on the intake pipe pressure sensor is causing the symptoms mentioned above. To rectify the fault, the intake pipe pressure sensor must be replaced if it is faulty. If the fault is caused by a connection problem (e.g. caused by vibration) in the multiway connector on the intake pipe pressure sensor, it is possible to fix the sensor using a cable tie, pay attention to the size of the gap (see photo).

Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.

The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.