Check and replace throttle valve potentiometer: Function and fault diagnosis

The throttle valve potentiometer informs the engine control unit about the opening angle of the throttle valve. The signal from this sensor is required to calculate the injection quantity, for example. This page explains the design and function of the throttle valve potentiometer. We will also show you which symptoms could indicate a fault in the sensor and how it can be checked in the workshop with simple means.

Important safety note

The following technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their day-to-day work. The information provided on this website is intended for suitably qualified personnel only.

1. Functional principle

How the throttle potentiometer works

The throttle valve potentiometer determines the opening angle of the throttle valve. This information is then forwarded to the control unit and used as a parameter for calculating the necessary fuel quantity. It is mounted directly on the throttle valve shaft.

The throttle valve potentiometer is an angle transmitter with a linear characteristic curve. It converts the respective throttle valve opening angle into a proportional voltage ratio. When the throttle valve is actuated, a rotor connected to the throttle valve shaft slides over resistance tracks with its sliding contacts, which converts the throttle valve position into a voltage ratio.

2. Symptoms

Throttle potentiometer faulty

A defective throttle valve potentiometer can manifest itself as follows:

  • Engine jolts and/or splutters
  • Engine accelerates poorly
  • Poor starting behaviour
  • Increased fuel consumption
3. Cause of failure

Causes of a faulty throttle potentiometer

Causes of throttle valve potentiometer failure can be:

  • Contact fault at the plug connection
  • Internal short circuits caused by contamination (humidity, oil)
  • Mechanical damage
4. Troubleshooting

Checking the throttle potentiometer

The following test steps should be considered during troubleshooting:

1

Check the throttle valve potentiometer

Check the throttle valve potentiometer for damage

2

Check the plug connection

Check the plug connection to ensure it is fitted correctly and for any contamination

3

Measure the resistance

Measure the resistance at the throttle valve potentiometer ( circuit diagram required for pin assignment). Connect the ohmmeter and check the resistance with the throttle valve closed; slowly open the throttle valve and monitor the change in the resistance (an interruption to the sliding contact can be identified during the measurement). Check the resistance with the throttle valve fully open (observe the manufacturer's specifications).

4

Check the cable connections

Check the cable connections to the control unit for continuity and a short circuit to frame (circuit diagram required for pin assignment). Check the continuity of the individual cables with removed control unit plug and component plug; reference value approx. 0 ohms. Also check each cable against vehicle ground for a short circuit to frame; reference value approx. >30 MOhm.

Cât de util ți se pare acest articol?

Nu este deloc util
5
4
3
2
1
Foarte util
Succes

Captcha incorectă

Captcha incorectă

Eroare

A apărut o eroare

Căutare piese de schimb
Nr. OE Identificarea manuală a vehiculului
Cei mai importanți producători
Alți producători
Seria de vehicule Înapoi
Vehicul Înapoi

Introduceți numărul OE în câmpul de introducere. De obicei, numărul OE se găsește pe piesa de schimb însăși sau în documentele vehiculului.

Căutare piese de schimb
De asemenea, identificați piesele de schimb cu numerele OE Informații detaliate despre produs Găsiți distribuitori en gros în apropierea dumneavoastră
dummy
Processing Selected Car
Poducători
Seria de vehicule
Vehicul
Puterea motorului
Cilindreea motorului
Tipul de combustibil
Anul de construcție
Codul motorului

Alegeți categoria:
Înapoi
dummy
Distribuie
Trimite prin Copiază linkul
Adresa URL a fost copiată în clickboard!
Numărul articolului
Number
Numărul articolului a fost copiat!
Căutare pe internet Instrucțiuni de montare
Mai multe detalii
Denumirea produsului Valoare
Mai puține detalii

Dealerul dumneavoastră
Autoteile Krammer GmbH
dummy
Lechstraße 1-3
68199 Mannheim
Afișează harta