Citroen C-Crosser - Stop lamp failure | HELLA



Model year: 2007 - 2009

Stop lamp failure

There have been complaints of a stop lamp failure on the aforementioned vehicles (warning light on instrument cluster lights up).

This problem is caused by a defective stop-lamp switch (soiled silicone on the contacts).

The vehicle manufacturer has already addressed the issue and notified the owners of all the affected models. For various reasons, however, it must be assumed that not all vehicles have been checked or modified.

Specialist garages will replace the defective stop-lamp switch in the affected vehicles with a new one.

To remove the stop-lamp switch, proceed as follows:

  • Remove the paneling above the pedal
  • Turn the switch one quarter-turn counterclockwise
  • Remove the switch
  • Detach the connector
  • To install the new stop-lamp switch, perform the above procedure in reverse
  • Once the new stop-lamp switch has been installed, test it to ensure that it works properly

Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.

The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.