If a customer complains about the above error, this could be caused by a defective plug connection. The following fault codes, among others, may be stored: B 1353 and B 2500. Due to a fault on the male connector housing of the wiring harness, this is not engaging correctly in the airbag control unit. In this case, the connector must be checked and replaced if necessary. The airbag control unit is located below the centre armrest.
When installing the new male connector housing, make sure it locks correctly. Delete the stored error codes.
Important safety information
The technical information and practical tips have been compiled by HELLA in order to provide professional support to vehicle workshops in their day-to-day work. The information provided on this website is intended for use by suitably qualified personnel only.
Reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express, written approval and indication of the source. The schematic illustrations, pictures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved. All rights reserved.