Citroen C4 - Bend lighting not functioning | HELLA

Citroen

C4

All models with xenon headlights

Model years to 10/2006

Bend lighting not functioning

If a customer complains about the above error, this could be caused by the rear axle sensor of the level control. In general, an error message is also displayed. The error message indicates that the bend headlights are malfunctioning. Do not be confused by this information. If a fault occurs in the AFS (Advanced Frontlight Systems) headlight systems, all AFS light functions such as dynamic bend lighting, static bend lighting, motorway lighting etc. are normally deactivated. This is also the case when a fault occurs in the level control. In this case, the rear axle sensor must be checked and replaced if necessary. Corrosion caused by ingress of water is often the cause of failure of the sensor.

Caution!

After repair, the new normal position of the sensor must be saved in the control unit. Follow the vehicle manufacturer’s instructions in this case.

Important safety notice
The following technical information and tips for practical use have been set up by HELLA in order to offer professional support to automotive workshops in their daily work. The information available here on this website is only to be used by appropriately trained specialist staff.

The reprinting, distribution, reproduction, exploitation in any form and disclosure of the contents of this document, even in part, is prohibited without our express written approval and indication of the source. The schematic illustrations, figures and descriptions are for explanation and presentation of the document text and cannot be used as a basis for installation or design. All rights reserved.